Broan EPLEC130SS Manuel d'utilisateur télécharger pdf (Page 10)

INSTALLATION MANUAL

INSTALLATION

4 ] Remove the screw holding the 3¼” x 10” adapter/damper as well as the one for the 3¼” x 14”

adapter/damper, remove their tape strips and and put the adapter/dampers aside. Save these

screws, they will be used later to hold the blower cover plate.

5 ] Remove both tape strips holding the 7” round adapter, and put the adapter aside.

6 ] Remove the parts bag taped in the lower left corner of the hood.

7 ] Using a 11/32” nut driver or socket, remove the lock nut retaining the flange of the right

blower cover plate (shaded part on illustration below) to the inner back of hood (see inset).

Remove the right cover plate remaining retaining screws (5 screws), then set the blower

cover along with its screws and nut aside.

NOTE: For 30 in.-wide hoods, slightly lift up the cover plate before sliding it towards the left to

remove it.

BACK OF HOOD

LOCK NUT

SCREWS REMOVED

IN STEP 4

REMOVE

AND SAVE

THESE

SCREWS

TAPE

PARTS BAG

TAPE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Pas de commentaire

Broan EPLEC130SS Manuel d'utilisateur Page 10