Broan EPLEC130SS Manuel d'utilisateur télécharger pdf (Page 7)

INSTALLATION MANUAL

INSTALLATION

For ADA compliance installation guidelines, please visit www.broan-nutone.com

Recommended Tools and Accessories

for Installation

• Measuring tape

• Phillips screwdriver no. 2

• Nut driver or socket 11/32”

• Flat blade screwdriver (to open knockout holes)

• Drill, 1/8” drill bit and 1½” hole saw (to mark holes for ducting and cut electrical access hole)

• 7/64” drill bit (to drill holes for EZ1 brackets mounting screws)

• Wood shims (2) and wood screws (4) (required for standard installation to framed cabinet)

• Saw (to cut holes for ducted application)

• Sheet metal shears (ducted installation only, for duct adjustment)

• Pliers (ducted installation only, for duct adjustment)

• Metal foil duct tape (for ducted applications)

• Scissors (to cut metal foil duct tape)

• Pencil

• Wire stripper

• Strain relief, 1/2” diameter (to secure house wiring cable to the hood)

Install Ductwork (Ducted Installations Only)

SOFFIT

18" MIN - 24" MAX

ABOVE

COOKING SURFACE

CABINET

3¼" X 10" OR

3¼" X 14" DUCT

(FOR HORIZONTAL DISCHARGE)

WALL CAP

ROOF CAP

3¼" X 10", 3¼" X 14" OR

7" ROUND DUCT

(FOR VERTICAL

DISCHARGE

)

HOUSE WIRING

(TOP OR BACK OF HOOD)

HOOD

NOTE: Distances over 24” are at the installer and user discretion.

1 ] Determine whether hood will discharge vertically (3¼” x 10”, 3¼” x 14” or 7” round),

or horizontally (3¼” x 10” or 3¼” x 14” only).

2 ] Decide where the ductwork will run between the hood and the outdoors.

3 ] Choose a straight, short duct run to allow the hood to perform most efficiently. Long duct

runs, elbows and transitions will reduce the performance of the hood. Use as few of them as

possible. When possible, use at least 2 foot straight runs before any turns. Larger ductwork

may be required for best performance with longer duct runs.

4 ] Install wall cap or roof cap (sold separately); ensure there is no leak in house insulation.

Connect metal ductwork to cap and work back towards the hood location. Use 2” metal foil

duct tape to seal the joints between ductwork sections.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Commentaires sur ces manuels

Pas de commentaire

Broan EPLEC130SS Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Broan EPLEC130SS