Broan B5630SS Guide d'installation télécharger pdf

MODELS B5630SS • B5636SS • B5730SS • B5736SS

Page 1

CHIMNEY

RANGE HOOD

VQ0009

Intended for domestIc cookIng only.

VQ0009

READ AND SAVE THESE INSTRUCTIONS

VQ0009

TO REDUCE THE RISK OF FIRE, ELECTRIC

SHOCK, OR INJURY TO PERSON(S) OBSERVE THE

FOLLOWING:

1. Use this unit only in the manner intended by the manufacturer.

If you have questions, contact the manufacturer at the

address or telephone number listed in the warranty.

2. Before servicing or cleaning unit, switch power off at service

panel and lock service disconnecting means to prevent

power from being switch on accidentally. When the service

disconnecting means cannot be locked, securely fasten a

prominent warning device, such as a tag, to the service

panel.

3. Installation work and electrical wiring must be done by

qualified personnel in accordance with all applicable codes

and standards, including fire-rated construction codes and

standards.

4. Sufficient air is needed for proper combustion and exhausting

of gases through the flue (chimney) of fuel burning equipment

to prevent backdrafting. Follow the heating equipment

manufacturer’s guidelines and safety standards such as

those published by the National Fire Protection Association

(NFPA), the American Society for Heating, Refrigeration

and Air Conditioning Engineers (ASHRAE) and the local

code authorities.

5. When cutting or drilling into wall or ceiling, do not damage

electrical wiring and other hidden utilities.

6. Ducted fans must always be vented to the outdoors.

7. Do not use this unit with any other solid-state speed control

device.

8. To reduce the risk of fire, use only steel ductwork.

9. This unit must be gounded.

TO REDUCE THE RISK OF A RANGE TOP GREASE

FIRE:

a) Never leave surface units unattended at high settings.

Boilovers cause smoking and greasy spillovers that may

ignite. Heat oils slowly on low or medium settings.

b) Always turn hood ON when cooking at high heat or when

cooking flaming foods (i.e. Crêpes Suzette, Cherries Jubilee,

Peppercorn Beef Flambé).

c) Clean ventilating fans frequently. Grease should not be

allowed to accumulate on fan or filters.

d) Use proper pan size. Always use cookware appropriate for

the size of the surface element.

WARNING

TO REDUCE THE RISK OF INJURY TO PERSON(S)

IN THE EVENT OF A RANGE TOP GREASE FIRE,

OBSERVE THE FOLLOWING*:

1. SMOTHER FLAMES with a close-fitting lid, cookie sheet, or

metal tray, then turn off the burner. BE CAREFUL TO PREVENT

BURNS. IF THE FLAMES DO NOT GO OUT IMMEDIATELY,

EVACUATE AND CALL THE FIRE DEPARTMENT.

2. NEVER PICK UP A FLAMING PAN – You may be burned.

3. DO NOT USE WATER, including wet dishcloths or towels –

This could cause a violent steam explosion.

4. Use an extinguisher ONLY if:

A. You know you have a Class ABC extinguisher and you

know how to operate it.

B. The fire is small and contained in the area where it

started.

C. The fire department has been called.

D. You can fight the fire with your back to an exit.

* Based on “Kitchen Fire Safety Tips” published by NFPA.

VQ0009

WARNING

CAUTION

1. For general ventilating use only. Do not use to exhaust

hazardous or explosive materials and vapors.

2. To avoid motor bearing damage and noisy and/or

unbalanced impeller, keep drywall spray, construction dust,

etc. off power unit.

3. Do not use over cooking equipment greater than 60,000

BTU/hr. as the blower motor will shut down intermittantly.

4. Your hood motor has a thermal overload which will

automatically shut off the motor if it becomes overheated.

The motor will restart when it will cool down. If the motor

continues to shut off and restart, have the hood serviced.

5. The bottom of the hood MUST NOT BE LESS than 30” and

at a maximum of 36” above cooktop for best capture of

cooking impurities.

6. Two installers are recommended because of the size of

this hood.

7. To reduce risk of fire and to properly exhaust air, be sure

to duct air outside. Do not exhaust air into spaces within

walls or ceilings or into attics, crawl spaces, or garages.

8. Be careful when installing the decorative flue and hood, they

may have sharp edges.

9. Please read specification label on product for further

information and requirements.

INSTALLER: LEAVE THIS GUIDE TO THE HOMEOWNER.

HOMEOWNER: OPERATION AND MAINTENANCE INFORMATION ON PAGE 8.

To register this product visit:

www.broan.com

HB0066

HB0067

1 2 3 4 5 6 ... 27 28

Résumé du contenu

Page 1 - RANGE HOOD

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 1CHIMNEY RANGE HOODVQ0009!Intended for domestIc cookIng only.VQ0009!READ AND SAVE THESE INSTRUCTIONS

Page 2 - PREPARE THE HOOD

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 10HOTTE DE CUISINE À CHEMINÉEVQ0009!Pour usage domestIque seulement.VQ0009!LIRE CES DIRECTIVES ET

Page 3 - WALL STUDS

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 11INSTALLATION DES CONDUITS (hottes avec conduits seulement)1. Planifiez la pose du conduit en dét

Page 4 - INSTALL THE HOOD

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 12CLINSTALLATION DU CÂBLAGE INSTALLATION DE LA BRIDE DE MONTAGE DE LA HOTE1. Construisez une charp

Page 5

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 13INSTALLATION DE LA BRIDE DE MONTAGE DE CONDUIT DÉCORATIF SUPÉRIEUR1. Percez deux trous de 7,9 mm

Page 6 - (Non-Ducted Hoods Only)

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 1410. Mesurez et installez un conduit rond de 15,2 cm (6 po) jusqu’au capuchon de toit ou capuchon

Page 7 - CONNECTOR

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 15INSTALLATION DE LA HOTTE (hotte sans conduits seulement)CONTENU DE L’ENSEMBLE MODÈLE RK56 POUR HO

Page 8 - MAINTENANCE

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 1616. La hotte étant suspendue en place, percez à travers les deux trous situés à l’intérieur de l’

Page 9 - WIRING DIAGRAM

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 17FONCTIONNEMENTLa hotte fonctionne à l’aide de quatre (4) boutons-poussoirs situés sur la face ava

Page 10 - CUISINE À CHEMINÉE

MODÈLES B5630SS • B5636SS • B5730SS • B5736SSPage 18PIÈCES DE RECHANGE99526963B12456791011121314Les pièces de rechange peuvent être commandées sur no

Page 11 - PRÉPARATION DE LA HOTTE

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 19CAMPANA DE ESTUFA DE CHIMENEAVQ0009!IndIcada solamente Para cocInar en casa.VQ0009!LEA Y CONSE

Page 12 - DE MONTAGE DE LA HOTE

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 2INSTALL THE DUCTWORK (Ducted Hoods Only)1. Decide where the ductwork will run between the hood and

Page 13 - INSTALLATION DE LA HOTTE

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 20INSTALE LOS CONDUCTOS (sólo en campanas con conductos)1. Decida dónde instalará el conducto e

Page 14

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 21CLINSTALE EL CABLEADO INSTALE EL SOPORTE DE MONTAJE DE LA CAMPANA1. Construya un bastidor de m

Page 15

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 22INSTALE EL SOPORTE DE MONTAJE DEL TUBO DE HUMOS SUPERIOR1. Perfore dos orificios de 5/16 pulg.

Page 16 - (4 7/8 PO)

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 2310. Mida e instale los conductos redondos de acero de 6 pulg. (15.2 cm) a la tapa para techo o

Page 17 - ENTRETIEN

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 24INSTALE LA CAMPANA (sólo para campanas para sistemas sin conductos)CONTENIDO DEL KIT PARA SISTE

Page 18 - GARANTIE

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 256. Retire los filtros de grasa estirando hacia abajo la cejilla metálica e inclinando los filt

Page 19 - ESTUFA DE CHIMENEA

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 26FUNCIONAMIENTOLa campana se hace funcionar con los botones en el panel frontal.Presione el botó

Page 20 - Página 20

MODELOS B5630SS • B5636SS • B5730SS • B5736SSPágina 27PIEZAS DE REPUESTO99526963B12456791011121314Se pueden hacer los pedidos de las piezas de repues

Page 21 - (21 cm) Máximo

99526963B

Page 22 - TUBO DE HUMOS INFERIOR

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 3CLINSTALL THE WIRING INSTALL THE HOOD MOUNTING BRACKET1. Construct wood wall framing that is flush

Page 23 - Página 23

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 4INSTALL UPPER FLUE MOUNTING BRACKET1. Drill two 5⁄16” diameter holes where shown. Insert drywall an

Page 24 - Página 24

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 510. Measure and install 6” round steel ductwork to roof cap or wall cap and 900 elbow over duct col

Page 25 - Página 25

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 6INSTALL THE HOOD (Non-Ducted Hoods Only)NON-DUCT KIT MODEL RK56 CONTENTSNON-DUCTPLENUM2 TIEWRAPSFLE

Page 26 - MANTENIMIENTO

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 76. Remove the grease filters by pulling down the metal latch tab and tilting filters downward to r

Page 27 - DIAGRAMA DE CABLEADO

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 8OPERATIONThe hood is operated using the push buttons on the front panel.Push the light button to tu

Page 28 - 99526963B

MODELS B5630SS • B5636SS • B5730SS • B5736SSPage 9SERVICE PARTS99526963B12456791011121314Replacement parts can be ordered on our website: www.broan.c

Plus de documents pour Hottes de cuisine Broan B5630SS

Voir le document Broan B5630SS Fiche technique

Broan B5630SS Fiche technique (0 pages)

Voir le document Broan B5630SS Guide d'installation

Broan B5630SS Guide d'installation (28 pages)

Commentaires sur ces manuels

Pas de commentaire

Broan B5630SS Guide d'installation

Naviguer en ligne ou télécharger Guide d'installation pour Hottes de cuisine Broan B5630SS. Broan B5630SS Installation Guide Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Hottes de cuisine Broan B5630SS

Commentaires sur ces manuels

Produits connexes et manuels pour Hottes de cuisine Broan B5630SS